Summer is coming and the grass has already grown noticeably, while it is not critical, but you should think about how to cut it. I will show how to make an easy trimmer from the grinder to mow the grass. More precisely, it will be a special device in which the grinder will be installed. After mowing, it can be removed again and used for its intended purpose. There is not much point in buying a ready-made trimmer if you need it only 1-2 times per season.I attach it to the angle grinder body. Marker notice the place of the bend.Then I clamp in a vise and bend it with hammer blows. I cut off the extra with the same grinder.In the tool body on both sides there are holes with threads.A handle is screwed into these holes in order to cut both from the left and from the right, the handle is made reversible. That's just for these holes and the trimmer bracket will be fixed. On the sides of the bracket it is necessary to drill the holes so that they coincide with the holes on the sides of the tool. We notice with a marker.Drill it in a vice.Next, in the bracket, you need to attach a guide along the length of an angle grinder or shorter.Weld by welding. We bring down the scale and we clean the brush on the metal.Now the bar-handle. It will be made of steel pipe. At the end of the pipe we will make a bevel so that the handle is fastened at an angle. Mark up the cut line with a marker.Sawing a corner.Weld by welding. We also knock down a scale with a hammer, brush it with a metal brush.Now it's time to install the grinder itself into the seat.To do this, unscrew the protective circle.So that the trimmer does not touch the ground and is at a certain distance, wheels will be attached to it. They can be taken from an old and unnecessary baby carriage or any other trolley. In the extreme case, make the most of wooden kruglyashey. I had wheels with brackets.Insert the Bulgarian into the seat.We put the wheel with the bracket and fix it all with a bolt. Well tighten the key. We do the same procedure from the opposite side.Ready trimmer to mow the grass is almost ready.It remains to make the cutting part. To do this, take the pieces of steel rope or a specialized nylon wire for trim tabs.We cross the cross-thread through the clamping nut, through the holes for the key.Screw the nut with cutting cables on the Bulgarian.Fix the wire with electrical tape.You need to get a long extension cord and you can mow.Mows quite tolerable.Before you finish, I would like to say that the Bulgarian is not intended for such work. And if you want to repeat this home-made product, then take full responsibility and use everything at your own risk. When mowing the grass, be very careful, the steel cable rotating at high speeds is very dangerous. All manipulations on mounting or dismantling the cutting part should be made only when the fork is pulled out of therosettes. And so the adaptation is necessary and it may well be useful for you to mow the lawn in front of the house.
How to make a trimmer from a grinder with your own handsThe first thing to do is to use a brace for gripping the body of a grinder. To do this, take a steel plate and bend on both sides of the body. I took the plate already bent on one side initially. Now I can only bend the second edge.
Original invitation to a bachelorette party
How to dress a full girl in winter
Sliding wardrobe with photo printing from the brand FlashNika: individuality in detail