How to putty and plaster walls

You will need
  • - two-meter level with adjustable eye;
  • - flat rake;
  • - grater made of foam or carbolite;
  • - latex gloves;
  • - Master OK;
  • - mortar for plaster;
  • - drill;
  • - dowels;
  • - fishing line;
  • - bucket;
  • - water;
  • - primer;
  • - brush;
  • - putty knife;
  • - putty mixture;
  • - sandpaper.
Instruction
Given the irregularitieswalls, determine the approximate thickness of the plaster layer. Depart from the corner by thirty centimeters and sketch the solution in small portions (the finishing surface will be 2/3 of the solution fromwalls). Make a vertical bed of nalyapannogo solution.
Then take the beacon and press it to the intended level, without ceasing to glance at the eye (wallsthe result should be smooth).
Drill several holes in the wall and drive dowels into them, on which you attach the fishing line (it should be taut, but at the same time allow the free to work as a rule).
Now proceed directly to the plaster process itself. Having pressed a little beacon into the solution and having supported the level on the caps of the self-tapping screws, look through the peephole of the level and, if necessary, align the wall by removing or adding cement mortar.
Then throwwallsBetween the lighthouses cement mortar and leave it to the solution gave a part of its moisture to the brick. Time in this case depends on the brick: the red brick absorbs moisture very quickly, white - more slowly.
After that, carefully remove the solution protruding from the lighthouse. Collect the removed solution in a bucket, dilute it with water and rub this gap on all gaps and voids. Then remove the beacons, rub the grooves and allow the plaster to dry.
After the plaster has dried, primer the wall.
Apply a small amount of putty to the wide trowel using a small trowel and, holding this tool at a twenty-degree angle to the surface, smear the contents of the trowel on the wall. Ideal - movement along the diagonal, since it makes it possible to simultaneously align both horizontally and vertically. For cornering the outer and inner corners, use the cornerputty knife.
After applying the puttywallsshould dry for about twelve hours, then sandwallssandpaper.
Offer from our partner
note
Remember: the thickness of putty putty at a time should not exceed five millimeters. Otherwise, cracks will appear on the wall due to a thick layer.
Helpful advice
To dry the cement layer faster in wet weather, add a little alabaster to it.


Related News


Milk porridge mode in a POLARIS multicooker
How to make a delicious pizza
Recipe for french fries in the oven
How to relieve pain during childbirth
Paper model of the F7F-3P Tigercat fighter
LBM Grinding Machine